How to print to Makerbot Replicator 2X using open-source tools

I’m trying to print on Makerbot Replicator 2X using open-source software instead using Makerware software.

Initially I used Cura: with Cura_Makerbot_standard_profile.ini. You just need to select File -> Open Profile and choose Cura_Makerbot_standard_profile.ini.

Unfortunately Cura 14.09 in my Debian Jessie/sid is not able to detect and communicate with Replicator2X over serial port (ttyACM0). Then I decided to “Save GCode …” and then convert this saved myfile.gcode to myfile.x3g that can be read by Replicator2X from SD Card.

$ gpx -g -m r2x myfile.gcode myfile.x3g

It “barely workes”. I noticed the object is printed more to right side of build bed. Then my suggestion is to put the object more to left side of Cura bed before saving the gcode file.

Conclusion: this approach is not mature enough, but could work if you really care about using only open-source software to control your Makerbot Replicator 2X.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s